Thanks: 0
Likes: 0
Dislikes: 0
L3-00.JPG
After several of these codes appearing on the Frontier SC machine, I noticed the spring (red) that applies tension to the CCD drive belt does not have enough tension on it, causing L3-00 codes. A simple washer (green) under the anchor screw shown in the picture above will alleviate this code permanently. With the SC model, the optic cavity can be accessed from the top, unlike the previous 401 machines.
Failing to plan is planning to fail!!!
Good catch! Thanks for sharing. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Posting Permissions
Reply With Quote
Bookmarks