I dont know what to name this problem , getting double image printing pls help me to solve this issue .. i have attached 3 different images of the printing ..i have changed new drum n charging roller as well..Thanks
I dont know what to name this problem , getting double image printing pls help me to solve this issue .. i have attached 3 different images of the printing ..i have changed new drum n charging roller as well..Thanks
He he.Me too!
Probably messed up with controller or laser unit.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
I doubt it could fix it but on that model you can update the software with a usb thumb drive. Now at 49.02. I don't think power would be an issue unless you have no ground or bad ground and there is a lot of voltage on the ground line. I don't know where you are or what your power is. Lots of people here are from all over. I was guessing at the main controller. Not sure but that model may only have one, some advanced models have a couple. The scanner is another possibility, I have had problems with those on that model, usually strange issues.
How is the internal print ? if ok then check the scanner cable /connector.
I am also facing same issue but when I reinstall drum unit it work fine for some time.. u can clean a strip placed led on it when u remove drum unit n dp. U will see that strip..
Try another drum unit, i had one doing the same.
IBM, Mita, Konica Minolta, Ricoh, Kyocera, HyPAS, Canon, Oce, Samsung, HP, TEO IP PBX/Unified Communications, Comptia Network+ Comptia PDI+ Certifications
this thread is 5+ years dead.
Bookmarks