MP 6001 with exit jams

[slimslob]

is that the one wth the flag or a reflector type sensor?

Flag. In fact if I remember correctly it is a reed switch with a magnet on the flag end.

[fshead]

Flag. In fact if I remember correctly it is a reed switch with a magnet on the flag end.

thanks
i ve seen the flag itself go where it gets a cutout over time on some older high speed sharps.

[fshead]

Flag. In fact if I remember correctly it is a reed switch with a magnet on the flag end.

you are correct it is the old school reed switch..
I am talking about the one mounted on the fuser unit itself at the entrance..

[Mark Bbb]

I have noticed significant less jams if the rear panel was disassembelt.
Probabely due to better air transport.
Even dough all filters were cleaned or replaced (very important).

[fshead]

Thanks
I cant chance some poor secretary having her hand eaten up when she goes to grab something that might have fallen..
I am going back wth reed switch and transfer belt as i saw mention in GG about transfer unit could cause it.

[fshead]

ok so i didnt want to tempt the gods of copiers but i swapped out the reed switch on monday,ran 200 copies and waited out the week for that dreaded call..

It came but this was for a waste toner full on their backup mpc401 and the mp6001 is still ticking away....
so thanks to all who offered up help...