Hey Guys,
I have a Bizhub C451 machine (yes i know its an older model, i actually have a few of them and they have never missed a beat, but i digress) I installed a Mailbin Kit MT-502 on one of the units to a FS-519 Finisher.
The machine now has the two output trays, plus the 4 output trays of the Mailbin kit.
When no one is printing the machine defaults to the upper tray of the "normal finisher output trays" not the mailbin kit. This machine services a little sub office of 4 users who each have a dedicated tray and this means every time of them prints, it actually doesn't start printing until the Maiblin kit has been moved into place wasting quite a bit of time throughout the day as the output trays are constantly moving up and down. The "normal" finisher output trays are only used for copying and staple prints so 75% of the time the mailbin kit should/would be in use. Not only this, I'm a little worried about wear of the finishers motors with the trays constantly moving up and down.
When installing the kit the manual calls for unscrewing a screw and moving a little lever forward, im wondering if this sets the default position of the finishers trays or is there a software setting for this?
All im looking to achieve is for the mailbin kit to be in position and ready to go at all times rather than the 1st of the finishers inbuilt trays.
Hope i've been clear enough, if i need to provide some pics to help picture the situation, just sing out.
Cheers for any help you can provide.
Shane
I have a Bizhub C451 machine (yes i know its an older model, i actually have a few of them and they have never missed a beat, but i digress) I installed a Mailbin Kit MT-502 on one of the units to a FS-519 Finisher.
The machine now has the two output trays, plus the 4 output trays of the Mailbin kit.
When no one is printing the machine defaults to the upper tray of the "normal finisher output trays" not the mailbin kit. This machine services a little sub office of 4 users who each have a dedicated tray and this means every time of them prints, it actually doesn't start printing until the Maiblin kit has been moved into place wasting quite a bit of time throughout the day as the output trays are constantly moving up and down. The "normal" finisher output trays are only used for copying and staple prints so 75% of the time the mailbin kit should/would be in use. Not only this, I'm a little worried about wear of the finishers motors with the trays constantly moving up and down.
When installing the kit the manual calls for unscrewing a screw and moving a little lever forward, im wondering if this sets the default position of the finishers trays or is there a software setting for this?
All im looking to achieve is for the mailbin kit to be in position and ready to go at all times rather than the 1st of the finishers inbuilt trays.
Hope i've been clear enough, if i need to provide some pics to help picture the situation, just sing out.
Cheers for any help you can provide.
Shane
Comment