vlad_robas
05-07-2016, 06:13 AM
Hi,
Before this code in the sim test pattern at 90 the coverage was't looking even at all. Consumable's weren't that bad and print was ok.
It stop's early after the start and show's this code.
Om the transfer belt are only two stripes, magenta and cyan, the third one, yellow, is still on the drum.
The belt is spining and i have read about other related post's on this mater. So I have clean the sensors on registration ass'y but that didn't help. Then taped the shutter in the open position.
I'm asking if it is ok to take the assy out and go to another machine and test it there or if is even related to that assy?
Before this code in the sim test pattern at 90 the coverage was't looking even at all. Consumable's weren't that bad and print was ok.
It stop's early after the start and show's this code.
Om the transfer belt are only two stripes, magenta and cyan, the third one, yellow, is still on the drum.
The belt is spining and i have read about other related post's on this mater. So I have clean the sensors on registration ass'y but that didn't help. Then taped the shutter in the open position.
I'm asking if it is ok to take the assy out and go to another machine and test it there or if is even related to that assy?