PDA

View Full Version : Error Code C253 CD3790


Custom Search


ck1
07-31-2016, 02:09 AM
this machine when i change new MFB board rewrite firmware and nvram recover still getting this code. any ideal thanks :confused::confused::confused:

blackcat4866
07-31-2016, 02:33 AM
Ok. I give up.

Ordinarily I would take a guess at an error code with too many digits, but I can't find anything even close. Let's try an error code with a "C" and four more digits. =^..^=

Woxner
07-31-2016, 03:20 AM
16.5.130 CD3##: NVRAM data error
• When the data stored due to the NVRAM trouble is lost, backup data can be used for restoration.
• Trouble code [C-D370] will be displayed when multiple errors (over 5) of NVRAM data
are detected, which can be restored with one restoration command.
• Data backup will be automatically performed every hour. Backup can also be performed
manually with the following setting.
[Service Mode] → [Enhanced Security] → [NVRAM Data Back Up]
See P.440
1. When a trouble caused by NVRAM data error occurs, the screen below appears.
2. Select [Yes] and touch [OK].
3. The screen will be shifted to the data restoration screen to perform data restoration.
NOTE
• When the restoration is performed in a short time, data restoration screen may not
be displayed.
4. Check the message which indicates that the data restoration was successfully conducted.
Turn OFF the main power switch and turn it ON again more than 10 seconds
after.
NOTE
• In case it failed to restore data, return to the trouble code screen.
A00JF4E517DA



Try this its probably a nvram error

Custom Search