Imsdal
11-15-2016, 11:09 AM
Hello there.
Have anybody had problems with this version K9 and M1 firmware with the bizhub e-series.
I canīt update the FS-534SD and the JS-506, when i start the update the display show N/G in both cases.
The only way I can update the machines is to disconnect the finisher. I have try with a new USB but no luck.
The finisher and the job separator work just fine..I just canīt update them
Has anybody any idea why this happen.
Sincerley
Imsdal
Have anybody had problems with this version K9 and M1 firmware with the bizhub e-series.
I canīt update the FS-534SD and the JS-506, when i start the update the display show N/G in both cases.
The only way I can update the machines is to disconnect the finisher. I have try with a new USB but no luck.
The finisher and the job separator work just fine..I just canīt update them
Has anybody any idea why this happen.
Sincerley
Imsdal