View Full Version : Error Code Konica Minolta 1050E with SC36-06, changed TH3 and TS2 can't get rid of code
Eleshuvio
10-12-2017, 10:56 PM
Replaced TH3 and TS2, Turn on service mode and it shows 3-0 not 3-1, doesn't matter what I change it to it still throws the code. Kida stuck at this point, any help would be appreciated.
Thank you,
Dave
tulintron
10-17-2017, 08:57 PM
Replaced TH3 and TS2, Turn on service mode and it shows 3-0 not 3-1, doesn't matter what I change it to it still throws the code. Kida stuck at this point, any help would be appreciated.
Thank you,
DaveCheck the I / O check if the thermistors are measuring correctly.Make sure the heat sinks are open.
Check switch DIPSW 03-1 = off
Check behind the ACDB, electrical components that cause fuser error codes.
mircea
10-19-2017, 07:43 AM
Replaced TH3 and TS2, Turn on service mode and it shows 3-0 not 3-1, doesn't matter what I change it to it still throws the code. Kida stuck at this point, any help would be appreciated.
Thank you,
Dave
Check fuser back conector for any dmg. Also there might be a fuse blown on your acdb or prcb. You can check all fuses for continuity with a mutimeter. Those fuses are noted with ICP on the board.
Best of luck
allan
10-19-2017, 12:06 PM
I had i similar problem on a B1250. Could not get it to work until i changed the funny looking one from a B601.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.