Bizhub C10 "Please wait"

[llla]

Hi.
I have a bizhub C10 with the message "please wait" stuck i display. Engine and fan`s starting up but "Please wait" msg stuck in display. :confused:

[jprecht]

when u pwr up do you see fuser lmp and hear cycling??? copier cycles then stops? may need to replace hdd and/or reflash firmware. have seen this on bizhub c250:eek: good luck!!!! jprecht p s did you "re-initialize"??? first not familiar with this unit but have several 250c 350c ect out there.

[llla]

I hear mc i cycles up. I`ll try to rewrite fw to see if that help. Thanks

[minimerlin]

Hi.
I have a bizhub C10 with the message "please wait" stuck i display. Engine and fan`s starting up but "Please wait" msg stuck in display. :confused:
Was the C10 asking for any units to be changed prior to this indication...sounds like it is trying to carry out a calibration.

[llla]

Was the C10 asking for any units to be changed prior to this indication...sounds like it is trying to carry out a calibration.

No, costumer had just turned it on and no other msg than "Please wait".
I tried to wait 10 min but msg was still there. I tried to power it off/on several times but it just starts engine, rotate whats supposed to rotate, I hear fans starting, just like normal. But msg say Please wait. So like jprecht I think it is fw or some electronical problem. I`ll try fw rewrite tomorrow.

[jprecht]

not familiar with this one but almost all bizhubs have a service pcb with two pins you short to re-initialize short pins cheat door sw depress service trouble reset button hold it down while turning on copier wait 10 sec, release i would try this first . good luck!!!

[llla]

I loaded new fw today but mc still show same msg, but I saw that exp lamp did not light up so I`ll try to change CCD assy.

[tarzak911]

not ccd ... fuser lamp...

[peter lynn]

Hi.
I have a bizhub C10 with the message "please wait" stuck i display. Engine and fan`s starting up but "Please wait" msg stuck in display. :confused:
the fuser is fed via a microswitc h operated by a plunger/on left side top covercheck pivot point ofthis operating lever--it breaks--and replace the switch (same as front door switch on 7033/7045)
you wll kiss goodbye to 2 hours for this.(follow change fuser instructions for access)
happy copying peter

[tech51]

Your spot on with the ccd/lamp assembly, just had a tech memo saying this is probable cause of please wait message. Go for it!!!

[xeroprint]

I have this same problem"please wait" . I change exp lamp and all scaner
in c10 from minolta di1610. Its works.

[nvram]

hi, i have had three units do this too.
si:mad:

[Scorotron Wizard]

I've got one doing it now, does anyone have a difinative answer?