PDA

View Full Version : Konica 7130 pm


Custom Search


SKTeK315
02-15-2011, 05:59 AM
7130 changed DV, drum & blade. Cleared maint., drum & DV counts. Timers & all. Couldn't figure it out so I turned it on & let it go through it's cycle. Naturally it popped a code. Didn't even looked at it. Had to be ATS code. I found & ran the " L " adj. Got a 0006 on left side. On right was 00600 or 60. A no go. What & howvto fix this. Tnx

barratec
02-15-2011, 09:37 AM
Try to change the TONER DENSITY SENSOR or ID SENOR or BOTH and perform the "L detection" adjustment.

CraigW
02-15-2011, 01:02 PM
Make sure your felts on the end seals did not come loose and roll up binding the drum.

Generic drum ?? We quit using them...could never get L-Detect to run with them installed, OEMs work perfectly every time for me.

SKTeK315
02-15-2011, 01:05 PM
Woldnt it throw a main motor lock code but I'll check

Luther
02-15-2011, 01:22 PM
also clean the sensor in the drum unit , setting powder or toner may have got it dirty

SKTeK315
02-15-2011, 01:34 PM
What about the order in of what to do after dv & drum change. I've read in a manual for a different model, it said to do "L" adj. then clear maint counts.

CraigW
02-15-2011, 05:04 PM
You would clear the counters 1st in both 25 & 36 mode and then run L-detect.

SKTeK315
02-15-2011, 05:10 PM
Tnx. I'll do that

humpty dumpty
02-15-2011, 05:16 PM
The sensor on the TCSB is dirty, resulting in improper output to the PRDB take out drum and clean small white rectangle sensor with swab

cheers matty

SKTeK315
02-15-2011, 05:20 PM
Tnx

Custom Search