View Full Version : Bizhub 600
Darren King
03-21-2011, 06:43 PM
I am working on a BZ600 that seems to lock up when the fax TX report prints. When it locks up you have to unplug machine to restore operation. I tested it several times with report on and with report off. Each time with report on it locked up, and each time with report off it didn't lock up. So I am kinda sure this is the problem.
Has anyone had this problem?
Leaving the TX report off is not an option unfortunately.
Thanks for the help
Darren
aesthetics1
03-21-2011, 07:47 PM
Try firmware first and foremost. Make sure you specifically update the fax board firmware when you do so, in addition to the rest.
I would try these steps in the following order:
1. Firmware
2. Data clear in service mode, and re-configure the device
3. Replace the fax kit/mount kit with a known good unit
4. Move on to boards and memory
Let us know how it goes.
Darren King
03-26-2011, 04:27 AM
Well I was at the machine Friday and udated the firmware. It seemed to fix the problem. I tested it and no lock-ups. I will call them Monday and find out for sure. Will update post when I find out. Thanks aesthetics1 for the advice.
Darren
RRodgers
03-26-2011, 06:21 AM
Well I was at the machine Friday and udated the firmware. It seemed to fix the problem. I tested it and no lock-ups. I will call them Monday and find out for sure. Will update post when I find out. Thanks aesthetics1 for the advice.
Darren
Stuff like that is almost always firmware related.
Darren King
03-31-2011, 01:34 PM
All seems well with the Bizhub600. Almost a week and no calls from customer
Thanks again
Darren
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.