View Full Version : mx 2600 n code c410
berg77
03-30-2011, 11:08 AM
can anyone help me to solve this mx2600n problem??? it says call for service code c410
divad2k1
03-30-2011, 12:44 PM
C4-10 PTC no control
Trouble content
Detail PCU
Cause The engine soft SW8-3 in SIM55-1 is set to "1".
The PTC control is not executed. (The PTC does not operate.)
When the engine soft SW8-3 in SIM55-1 is set to "1", the PTC output, the heater control, and the error detection are disabled. When this setting is made in case of a PTC unit trouble, the PTC function is disabled regardless of the PTC trouble and printing operation can be performed.
Check & Remedy Set the engine soft SW8-3 in SIM55-1 to "0".
(The mode returns to the normal PTC control mode.)
Nachoman4life
03-30-2011, 02:08 PM
Replace Primary Transfer corona
JustManuals
03-30-2011, 11:39 PM
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
berg77
03-31-2011, 07:14 AM
thanx
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.