mx 2600 n code c410

[berg77]

can anyone help me to solve this mx2600n problem??? it says call for service code c410

[divad2k1]

C4-10 PTC no control

Trouble content
Detail PCU
Cause The engine soft SW8-3 in SIM55-1 is set to "1".

The PTC control is not executed. (The PTC does not operate.)

When the engine soft SW8-3 in SIM55-1 is set to "1", the PTC output, the heater control, and the error detection are disabled. When this setting is made in case of a PTC unit trouble, the PTC function is disabled regardless of the PTC trouble and printing operation can be performed.

Check & Remedy Set the engine soft SW8-3 in SIM55-1 to "0".

(The mode returns to the normal PTC control mode.)

[Nachoman4life]

Replace Primary Transfer corona

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

[berg77]

thanx