PDA

View Full Version : konica 7145 j-30


Custom Search


DOE
11-10-2011, 06:19 PM
i have a konica 7145 that jams as it comes out of fuser and i get a j30. it comes 2 inches out of machine like it would when you have wrong paper size chose on paper dial. the machine runs fine if you use bypass. i have run singles through top drawer and they jam but not always. exit sensor and actuator look good. nothing broken. seams to do better out of drawer 4 not nearly as many jams but when it does its the same jam. all rubber is clean and good. any ideas. thank you for any advice

jrf
11-11-2011, 04:46 AM
The lower fuser roller can have a flat spot all across it and cause jams

DOE
11-14-2011, 03:59 PM
replaced upper, lower fuser roller and fuser exit switch. customer says its better but still get some j30 jams

Custom Search