View Full Version : Needed Service Manual for Finsher
LaserSharp
10-23-2007, 10:35 PM
Sharp- AR-BC260 Finshisher continues to give error F1-15
Could really use a service manual on this one, and perhaps a place for parts.
JustManuals
10-23-2007, 10:45 PM
What is the model number of the finisher?
Paul@justmanuals.com
blackcat4866
10-24-2007, 01:10 AM
Its an AR-F13 and I've got it. Send a private message w/ email address. ETA: 24hrs.
blackcat4866
10-24-2007, 01:32 AM
Oh, yeah! F1-15 is a tray lift error.
1) Trash can or some other obstacle blocks movement of the lift tray. Move the trash can.
2) Someone bumps the tray while its lifting. Turn Off/On to reset.
3) The finisher is lifted by the tray. The tray brackets become bent up. As a result the tray misses the actuator on the flat part of the left side of the finisher. Most of the time the brackets can be straightened. In a few cases they were just too distorted. I replaced those.
4) Customer falls on the finisher. Same effect as #2 except bent down instead of bent up.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.