View Full Version : Error Code KM 6500 Error code after developer change c2414
jptaylor45
02-08-2012, 02:04 PM
I am working on a KM c6500 and did the developer change for the black unit and followed the book exactly. When I do the "Toner Density Sensor Int." I get the error code 2414. I tried removing the developer and starting over, even used a new developer unit and keep getting the same results. Any ideas?
ni311
02-08-2012, 03:15 PM
Is the 2wire cable connected to the connector on the front of the developing unit?
jptaylor45
02-08-2012, 03:26 PM
Yes, all wires are conected. I replaced the developer again, re-set the counter, and still the same 2414 code
jptaylor45
02-08-2012, 03:31 PM
When I take it out of service mode it goes to error code c2424
ni311
02-08-2012, 03:56 PM
Did you follow the exact steps in the service manual, in that strict order? If yes, maybe the TCR sensor is faulty. Check the post below, it might help you:
http://www.copytechnet.com/forums/konica-minolta/59826-c6500-assistance-needed-error-c-2451-a.html#post265520
MarvinBCP
06-26-2015, 07:08 AM
When I take it out of service mode it goes to error code c2424
I have the same problem on my 6000L. Where you able to resolve the issue?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.