paulrid
04-12-2012, 03:28 PM
Hi all,
First off I hope this makes some sense.
When I print a lattice pattern all the lines are square and when I copy if off the glass they are also square but when I copy it through the ADF the vertical line about the 5th square down is jagged. Also the square 3 from the bottom is not straight. All the rest seem o.k. Any ideas?
Thanks in advance Paul.
First off I hope this makes some sense.
When I print a lattice pattern all the lines are square and when I copy if off the glass they are also square but when I copy it through the ADF the vertical line about the 5th square down is jagged. Also the square 3 from the bottom is not straight. All the rest seem o.k. Any ideas?
Thanks in advance Paul.