PDA

View Full Version : magicolor 2430dl


Custom Search


rbell12
07-19-2012, 03:06 PM
customer brought this machine in with regristration problem. image shifts 1/2" down the page. we have no reference materials for these boxes. looks like the paper has no stop at the registration. this on both internal prints and prints from the computer. any help would be greatly appreciated. rb

kingarthur
07-19-2012, 03:41 PM
try reposting in the "konicaminolta" section, it might get noticed more by those who know

JustManuals
07-19-2012, 06:56 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

nmfaxman
07-19-2012, 07:44 PM
Replace the feed rollers in the tray.
Worn sep causes the paper to feed an extra sheet that throws off the timing.

Hansoon
07-19-2012, 08:38 PM
Try first replacing the black pad on the synchro roller solenoid and relube the clutch. All machines of these series have EXACTLY the same error. Machine in the picture is a MC-2490MF but construction (not location) of the solenoid for the MC-2430 is similar.

Location of the synchro clutch and solenoid however is hard to reach and will take for the first time one hour labor.


16643


Hans

rbell12
07-24-2012, 05:28 PM
Thank you Hans. Replaced that solenoid with one from a 2590. Works like a champ. The input from everyone was much appreciated.

Hansoon
07-24-2012, 05:34 PM
Glad if I could help. Hopefully you took the opportunity to re-lube the clutch itself as well.

Hans

apachelry
11-15-2012, 09:04 PM
I have a 2490MF and probably the same problem : paper is not fully printed (offset of 4 centimeters above the sheet).the sheet is not completely ejected from the printer
the error message "paper jam" appears.
do you think it's the same problem ?

apachelry
11-15-2012, 10:20 PM
Incredible! It works!
My little black pad was not at all sticky ... I put tape around and that's it!
I don't not understand what has changed but it works ... thank you!

Hansoon
11-16-2012, 03:25 AM
Great! Thanks for the feed back.

Hans

Custom Search