MrB
10-10-2012, 07:33 PM
Hi All again
(Been a while since i was here last)
We have a iRC3580 with a J1 Fiery on it, and the end user are using Mac's & PC's
We are getting a lot of Error E747-8000 from both platforms
So far we have.....
Replaced and reloaded the fiery J1 HDD
Replaced the Main controller and the open interface PCB and added another dimm (on the device making 1.5gig)(No idea why that was done)
Replaced the motherboard pcb and added another 256mb dimm to the J1...
Banged our heads against the wall...
and now ran out of ideas..
Any suggestions will be grateful
(Been a while since i was here last)
We have a iRC3580 with a J1 Fiery on it, and the end user are using Mac's & PC's
We are getting a lot of Error E747-8000 from both platforms
So far we have.....
Replaced and reloaded the fiery J1 HDD
Replaced the Main controller and the open interface PCB and added another dimm (on the device making 1.5gig)(No idea why that was done)
Replaced the motherboard pcb and added another 256mb dimm to the J1...
Banged our heads against the wall...
and now ran out of ideas..
Any suggestions will be grateful