doug94550
11-07-2012, 08:18 PM
Hi Guys,
I have a 751 that is throwing a constant C-6708.
The machine initializes normally and when it gets to the point of the exposure lamp lighting the lamp flickers.
I figure that the inverter board on the exposure lamp assembly is the culprit.
However according to the documentation, I should be going for the CCD assembly.
Has anyone seen this one?
I am very new to this particular product with a population of one.
Thanks in advance,
Doug
I have a 751 that is throwing a constant C-6708.
The machine initializes normally and when it gets to the point of the exposure lamp lighting the lamp flickers.
I figure that the inverter board on the exposure lamp assembly is the culprit.
However according to the documentation, I should be going for the CCD assembly.
Has anyone seen this one?
I am very new to this particular product with a population of one.
Thanks in advance,
Doug