PDA

View Full Version : Bizhub 163 is not printing


Custom Search


spree
12-13-2013, 03:02 PM
I have a problem with Konica Minolta Bizhub 163.
The machine is like a new with very few copies, but have a serious issue.
I firstly configure the IP address, but have no ping.
Then I plug it to USB and tried to install through installer.
Installation completed correctly.
I tried to print a test page, but nothing happened, it was still in queue.
On display there was no information, it was ready.
Copying is working.

I tried it install on Win XP PC and Win 7 32-bit PC.
Please, have you any ideas or suggestions what can cause it and where can be a problem?

Thanks.

Hansoon
12-13-2013, 04:30 PM
What's the history of the machine? Is it a lease return or something? Could be that somebody messed up with the additional IC-206 controller and/or NIC interface NC-503.

This machine comes standard with a GDI interface with USB only. To install the above mentioned controller and NIC it needs special setup.

Hans

spree
12-13-2013, 05:21 PM
It's probably lease return.
It have only 3000 copies overall and look very good.

I've installed always PCI drivers.

Which special setup is needed?
Can you describe it?
I have all service manuals for it.

Custom Search