PDA

View Full Version : Jamming km bizhub c7000


Custom Search


molson
03-07-2014, 02:40 AM
copies come out wavy when coming out face down and jam going into duplex machine has only 70k on it cleaned all feed tires and replaced decurling roller any suggestions ?

Avskrap
03-07-2014, 11:55 AM
Have you checked the sensor flag (P/N 65AA51311) after the fuser going into the ADU? It gets worn, should be rounded but gets pointy with time, especially if the customer is running alot of heavy stock. This causes wavy paper and jams (J-3202).

gurko_gg
03-11-2014, 10:25 AM
Hello,

Can you try ADU drive board?

Change the dipSW 11-7 to on. You will be see jam code when change this dipSW.
Plase Let us jam code


Regards.

Gürkan.

texchar555
03-14-2014, 02:49 AM
there is a metal cleaning blade that is spring loaded replace it. I had once before when you flip it you will see why. its catching the worn area and causing the wave.

faizel
03-17-2014, 12:19 PM
hi
i have the same issue with wavy paper, i have replaced the complete turnover section and the problem came back after 1 day .
have you sorted this pls advise

faizel
03-24-2014, 07:38 AM
hi problem sorted


[Solution]
Please replace fusing separation plate assy.
Refer to the replacement procedure in theservice manual "F PERIODICAL MAINTENANCE 5.13.3 Replacing the fusingseparation plate assy".
When similar problem occurs in C6500 seriesand C5500 series, Please replace respective assy with that of C7000series.

Parts Name:fusing separation plate assy
Parts Number:A1DUR74H00

molson
05-09-2014, 02:56 PM
replaced duplex spring loaded curved guide plate under decurling assembly and took care of problem thanx

Cheesy
05-10-2014, 01:04 PM
hi check the Black Myler in the duplex unit. It starts to peel off and causes paper jam. Remove Myler. You could also have a faulty adu drive board. Check icp's on Adu board and in io check mode test duplex drive motor. Hope this helps.😄

Custom Search