PDA

View Full Version : Minolta CF2001 Error C13CC


Custom Search


Tim C
04-09-2008, 03:53 PM
Minolta CF2001 Error C13CC . Any Resets on this

bowser
04-11-2008, 07:09 AM
C13CC New Oil Coating Unit
resetting failure
The output from the new unit detecting terminal
remains HIGH and the copier does not recognize
that a new unit has been installed.
1. The fuse blowout signal of the new unit is set to a
blowout state.
2. After the lapse of 0.5 sec. after step 1, the fuse
blowout signal is brought to a state where no
new units are installed.
3. After the lapse of 0.1 sec. after step 2, a new unit
check sequence is carried out.
A total of two cycles of steps 1 to 3 are carried out
and, if the copier fails to detect a new unit a second
time, a malfunction condition results.


try trouble reset (butten is inside pin hole behind front door under image unit removing handel.
if it comes back you might have blown the board

Custom Search