PDA

View Full Version : C1060 pro banner printing


Custom Search


bronzegixer
08-01-2014, 06:31 PM
Hi All
can someone tell me the engine Dip Sw so we can enable banner printing

Mick01
08-05-2014, 02:28 AM
10-0 to on

bronzegixer
08-19-2014, 02:15 PM
10-0 to on

Hi Mike

Yes thought it was same as on the old c5501 10 - 0 to 1 also 10-1 to 0

It worked ok with the finisher on but now we have put the RU 509 decurler /online denistometer on between the machine and finisher, it wont work go all the way through, stops just before it starts to come out the finisher, I think its maybe due to different speeds in the machine, any Ideas or will it be a case of pulling these 2 units off each time.

thanks k

hotfuser
08-19-2014, 04:24 PM
10-0 to on

i have enclosed a document that KM have released regarding banner printing on the C1060.

i hope this helps.

samanthaevans
09-25-2014, 12:32 PM
I’m not really a pro when it comes to printing especially the large ones. For banner printing, we usually send it to SLB Printing. I’m learning to print now, especially when my brother bought C1060 last summer. Anyways, thanks for the help everyone!

Massy
04-20-2016, 08:48 PM
Hi Mike

Yes thought it was same as on the old c5501 10 - 0 to 1 also 10-1 to 0

It worked ok with the finisher on but now we have put the RU 509 decurler /online denistometer on between the machine and finisher, it wont work go all the way through, stops just before it starts to come out the finisher, I think its maybe due to different speeds in the machine, any Ideas or will it be a case of pulling these 2 units off each time.

thanks k


Hi Guys,

I know this is a bit of an old thread but can someone guide me on where to find the Dip Sw on the KM1060?

Many thanks.

Synthohol
04-20-2016, 10:32 PM
0px; "> (2) Procedure
1. "Service Mode menu screen"
Press [03 System Setting].
2. "System Setting Menu screen"
Press [01 Software DIPSW Setting].
[Service Mode] → [System Setting] → [Software DIPSW Setting]
3. "Software switch setting mode screen"
Press [▲] / [▼] or numeric buttons after you press the "DIPSW number" and "Bit number" buttons.
4. Press [On (1)] or [Off (0)] to configure the selected bit number ON/OFF.

Massy
04-20-2016, 11:28 PM
0px; "> (2) Procedure
1. "Service Mode menu screen"
Press [03 System Setting].
2. "System Setting Menu screen"
Press [01 Software DIPSW Setting].
[Service Mode] → [System Setting] → [Software DIPSW Setting]
3. "Software switch setting mode screen"
Press [▲] / [▼] or numeric buttons after you press the "DIPSW number" and "Bit number" buttons.
4. Press [On (1)] or [Off (0)] to configure the selected bit number ON/OFF.

Thanks for your help.

How do I get to "Service Mode" please?
Pardon my ignorance, I am new to KM machines. More familiar with Xerox's.

Does anyone have a service manual to share?

Many thanks.

Custom Search