methogod
08-30-2014, 05:00 PM
C6501 w/ 3m on it.. Great machine, well taken care of, runs hard and runs well....
About a few months back i found it "harder to close and lock the process unit into place."
Now its getting even harder, as i have to really use some force to slam it shut.
Nothing has been changed or replaced in that area... I let DV units go way past due but i have always done that....
Tech suggested replacing the locking arms on the process unit (the left side never has any issues only the right side or DV side.
when i compare to other C6501 and C7000 i have less play on this machine then others, but you would think that a good thing. I notice the little black rollers that allow the lock to close are marking on the metal it rubs on when closing.
Ill post a video today... no issues in the process unit that i can see or feel... And it runs fine just worried something is off and by forcing it closed even-though it works now i am stressing parts that dont need to be...
About a few months back i found it "harder to close and lock the process unit into place."
Now its getting even harder, as i have to really use some force to slam it shut.
Nothing has been changed or replaced in that area... I let DV units go way past due but i have always done that....
Tech suggested replacing the locking arms on the process unit (the left side never has any issues only the right side or DV side.
when i compare to other C6501 and C7000 i have less play on this machine then others, but you would think that a good thing. I notice the little black rollers that allow the lock to close are marking on the metal it rubs on when closing.
Ill post a video today... no issues in the process unit that i can see or feel... And it runs fine just worried something is off and by forcing it closed even-though it works now i am stressing parts that dont need to be...