Bad Problems

[zaza]

Hello we have error code E805 in canon 2420 ...please help ?

[Gazzahos]

Hello we have error code E805 in canon 2420 ...please help ?

E805-0000 (Main body fan error)
When the cooling fan of the main body starts, the fan lock detection signal (FAN_LOCK) has been held at the "H" level for longer than the prescribed time.

[zaza]

[QUOTE=Gazzahos;476819]E805-0000 (Main body fan error)
When the cooling fan of the main body starts, the fan lock detection signal (FAN_LOCK) has been held at the "H" level for longer than the prescribed time.[/
well in your opinion where is the solution to solve this problems ?

[blackcat4866]

[QUOTE=zaza;476821]

E805-0000 (Main body fan error)
When the cooling fan of the main body starts, the fan lock detection signal (FAN_LOCK) has been held at the "H" level for longer than the prescribed time.[/
well in your opinion where is the solution to solve this problems ?

Are you going to have Gazzahos go fix it for you also? =^..^=

[Gazzahos]

[QUOTE=blackcat4866;476822]

Are you going to have Gazzahos go fix it for you also? =^..^=

For an MFD that old I would start at blowing out all dirt from the fan and possibly running it on a Power Supply at the office to test. Or take a fan out of your stock and try that for a quick "Blow n Go".
Very rarely for a fan is it control signals or internal power supply. Being in Algeria I do not know the environment you are in or what area the MFD is in.

Its a good chance to offer them a newer MFD though!

Pay my flights and accomodation and I will fix it for you ANY TIME! (It can't cost that much from Melbourne, Australia to Algeria...could it?)

[Jhonjon]

This is a kind of thread that ask for a solution, but didn't do first what he have done to fix the problem. Give a possible cause still ask for the solution.

[teckat]

Check the fan connector. -
J219 DC PCB

Replace the fan. - Replace the DC controller PCB.

What more do u need._?
Basic Checks___DUH!!!!!