Hello friends,
my canon ir2520 copier is displaying E000202 error Message on the control panel.
what should i do?
Hello friends,
my canon ir2520 copier is displaying E000202 error Message on the control panel.
what should i do?
--------------------------
u sure u have that code correct
e000-020 ??
================================================== =========
investigate first---------------Fixing Unit
How to clear
E000, E001, E002 and E003.
Enter service mode by pressing additional functions than 2 than 8 and then Additional Functions.
#SSSW will be displayed.
Use the right arrow and scroll to #CLEAR then press OK.
Use the right arrow and scroll to ENGINE then press OK.
ERRCLR will be displayed then press OK. Then power cycle the machine.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Dear Sir,
the message is E000202 , it is not separated it displays on control panel at the start-up
Appears to be a Fixing temperature issue/
investigate first---------------
Remove & Inspect the Fixing Film Unit//
-Check connection of the Connectors (Thermistor Connector and AC Connector).
-Check for Jammed Paper
Open the right cover
Remove two screws
Pull out unit/ be careful
Fix Unit.jpg
-------------------------------------------------------------
How to clear Errors___________________>
E000, E001, E002 and E003.
Enter service mode by pressing additional functions than 2 than 8 and then Additional Functions.
#SSSW will be displayed.
1-Use the right arrow and scroll to #CLEAR then press OK.
2-Use the right arrow and scroll to ENGINE then press OK.
ERRCLR will be displayed then press OK.
3-Then power cycle the machine.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Teckat,
thank you for the support,
this problem look to be fixing unit power-related.
i have even tried to clear that message but it keeps on popping.
currently, i have sent this copier to canon service center for the warranty support.
i will update you if the problem is solved and how it has been solved.
E202 - There is an error in the detection of the CCD home position. The attempt to detect the home position fails when the CCDis moved forward.
1.Disconnect and then connect the flexible cable(Relay PCB(PCB2)-Main Controller PCB (PCB1) 64pin).
2.Replace the flexible cable.
3.Replace the CCD HP sensor (S22).
4.Replace the Scanner Motor (M21).
5.Replace the Relay PCB (PCB2).
6.Replace the Main Controller PCB (PCB1).
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hidius,
is the E000202 error code same as E202?
if it the same, please send me the illustrations for these mentioned parts so that i can find them easily in the copier.
i have another out of warranty with the same problem but it is occasionally
=================
Forgot that some Canon models post that misleading display of three zeros before actual code.
That appears to be the correct code E202
codes are different
E000 is a heat related code
E202 is a CCD Home Position Issue (as Hidius posted / there are listed steps to check-preform )
There is a shading adjustment (executed at power-on) by CCD unit-
Basic Sequence at Power-On
F: Scanner motor moves forward
B: Scanner motor moves backward
Light-ON: LED on CCD unit lights-on
ON: When CCD HP sensor (photo interrupter type) detects
CCD.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
thank you guys for the support,
the canon service center has worked on it, it was a scanner problem
Bookmarks