Hi
I have a problem with ir5075n. See a att.
Upper 1/3 of page a have some light area. Print and copy give same result. I'm not sure where is problem. I suspect: Drum, dev or pre-charge corona. Thanks on help.
Hi
I have a problem with ir5075n. See a att.
Upper 1/3 of page a have some light area. Print and copy give same result. I'm not sure where is problem. I suspect: Drum, dev or pre-charge corona. Thanks on help.
There is no stupid question, just stupid answer
Direction is from left side. Paper from deck2 A4. Device have 1,5M copies. Last time all coronas and dev is replaced when device meter have cca 1.2M copies. Also drum cleaner is changed before 200k copies. Duplex printing gives same result from both side. Paper is Double A 80g.
There is no stupid question, just stupid answer
YesTest.jpg
There is no stupid question, just stupid answer
the laser unit and the dust proof filter should be cleaned
U need to adjust the primary corona wire screwdriver always this happen with me also you can go to servicd mode function develop raise the decrease the value from 180 to 135 and the next one put it -20 and check the copy if any changes happen .
Distinguished road makes you jewel in rough
Just rewire your coronas. copier 101
Bookmarks