I have a IR7105 that has missing print as if the dev roller is not turning at first or a short in the coronas. It only happens for the first page if the machine has not been run in hours. Anyone seen this on this machine.
I have a IR7105 that has missing print as if the dev roller is not turning at first or a short in the coronas. It only happens for the first page if the machine has not been run in hours. Anyone seen this on this machine.
This is the sample. It happens almost always everyday first print. see sample print of this first page, then after the first page it is fine. IR7105 PRINT ISSUE_20150904080634.pdf
Thanks!!
hi
have you changed the Corona's?
what happens if you do a wire clean?
does the deletion location change?
what happens on a very long run, is there any deletions or fade out?
"Who loves the roses,must also bear thumbs"
All the coronas have been changed and the toner on dev roller looks good and uniform.
When running a long run (200+ pages) it works fine after the first page when this issue occurs. The sample; note the drop out in the first 1 1/2" for about an 1" then it comes back. This sample is only of a half page of print to begin with. It is with the first half of the page that the drop out occurs for the 1" blank area.
Re-wire the transfer/sep......
Hi having put the question to my team,
Laser as mentioned by another engineer above.
Bias contacts
Ap kit would cover drum.
Even though its ok on a long run its dropping charge somewhere.
Bookmarks