Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
250+ Posts
- Rep Power
- 27
Advance 4035 inner finisher-d1 problem
I am getting a e567-002 error when starting up. I know what the book says to do, but as usual the book has no field experience. Is there a more common remedy other than replacing the sensor ,motor or board? If not what part should be replaced first and if you have a part number it would be greatly appreciated. Many years ago we use to have a problem with a scanner motor trying to go forward and reverse at the same time and it would make the same chattering noise.
-
Re: Advance 4035 inner finisher-d1 problem
It has been found, a defective or displaced MSW2, in the Inner FinisherD1, may cause the above code to be displayed.
The part number for the switch is FM4-2152-000.
Also__
ck if the CN12 and CN13 are connected to the correct motors.
CN12 goes to M6
CN13 to M5
See
https://www.dropbox.com/s/u0sbp01kqhql27k/e567.url?dl=0
Last edited by teckat; 09-26-2015 at 06:02 AM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks