003-0202 and 002-0211 error codes on startup? c7000vp Imagepress

[joescalante]

Thanks, to everyone, I got the sensor cleaned, got it put back together. Now I get two different new codes.

003-0202 and
002-0211

They are not on the manuals list of codes so I have no clue where to turn.

[teckat]

Thanks, to everyone, I got the sensor cleaned, got it put back together. Now I get two different new codes.

003-0202 and
002-0211

They are not on the manuals list of codes so I have no clue where to turn.

Codes are in Service Manual

QUOTE] Thanks, to everyone, I got the sensors cleaned, got it put back together. Now I get two different codes.
003-0202 and 002-0211
------------------------------------------------------------------------

-When a following error occurs, after taking appropriate action (remedy),THIS MEANS TO INVESTIGATE THE AREA/UNIT OF CAUSE-- be sure to turn ON the power, and then select the following to execute ERR: COPIER > FUNCTION > CLEAR > ERR. The error is cleared by turning OFF and then ON the power after ERR execution.
E000, E001, E002, E003, E004, E013, E717, E719

E002 = Error in temperature difference between the center and the edge of fixing roller
x=
1: Primary fixing
2: Secondary fixing
Fixing roller main thermistor:
THM301(primary fixing),THM306(secondary fixing)
Fixing roller sub thermistor:
THM304(primary fixing),
THM309(secondary fixing)
Fixing external driver PCB: UN304(primary fixing), UN305(secondary fixing)
Fixing duplexing feed driver PCB: UN311

0x11 Error: software detection in temperature difference at fixing roller.
When the software detects that the temperature difference between the fixing roller's main and the sub
thermistors is 100 deg C or more for 1 sec continuously.

1. Check that the fixing roller main/sub thermistors are clean and properly installed. => Clean and reinstall them if necessary.
2. Check for any disconnection/improper connection of the following connectors.
=> Disconnect and then connect them if necessary.
- fixing roller main/sub thermistor
- between the fixing roller main/sub thermistor and the fixing external driver PCB
- between the fixing external driver PCB and the fixing duplexing feed driver PCB
3. Replace the fixing roller main/sub thermistor if necessary.

================================================== ==============================

E003 = Error in abnormally low temperature of fixing assembly.
Error: low temperature detection of fixing roller sub thermistor
When detecting temperature at standby/during print decreases by 30 deg C or more against the target temperature for 1 sec or more.

x=
1: Primary fixing
2: Secondary fixing
Fixing heater: H306(primary fixing), H300(secondary fixing)
Fixing heater driver PCB: UN306(primary fixing), UN307(secondary fixing)
Fixing roller sub thermistor:
THM304(primary fixing),
THM309(secondary fixing)
Fixing external driver PCB: UN304(primary fixing), UN305(secondary fixing)
Fixing duplexing feed driver PCB: UN311

0x02
1. Check for any disconnection/improper connection of the following connectors.
=> Disconnect and then connect them if necessary.
- fixing heater
- heater harness relay connector inside the fixing assembly
- fixing heater driver PCB (J4404)
- fixing roller sub thermistor
- fixing external driver PCB (J4192)
- fixing duplexing feed driver PCB
2. Check that the fixing roller sub thermistor is clean and properly installed.
=> Clean and reinstall it if necessary.
3. Replace the following parts if necessary.
- fixing heater
- fixing heater driver PCB
- fixing roller sub thermistor