IR 2520

[wassem]

hi everybody

i have a jam of code 0205

it is only appears in the third or fourth paper of a duplex job

the paper stops in the duplex pass and the machine continue rotating for about two minetes

after that the jam happened

i tried to upgrade the firmware from 7 to 77 version with no advance

###if i use A4R no problem#####

i checked the pre registration sensor and it is ok

anyone can help please

[teckat]

hi everybody

i have a jam of code 0205

it is only appears in the third or fourth paper of a duplex job

the paper stops in the duplex pass and the machine continue rotating for about two minetes

after that the jam happened

i tried to upgrade the firmware from 7 to 77 version with no advance

###if i use A4R no problem#####

i checked the pre registration sensor and it is ok

anyone can help please

==============================================
0205 Jam Code
stationary jam at the Pre-registration sensor S5.


go to SERVICE MODE>#PRINT>#PRINT NUMERIC>61 and change the value to 165
a wrap to sensor actuator spring for S7 Duplex Feed Sensor
try replacing the Second Reverse Delivery PCB Assembly
Duplex Feed clutch (CL4)/ FK2-9154-000



1--
1. Be sure to execute ''ALL CLEAR'' after upgrading the System Software from v50-xx
or earlier' to 'v61-xx or later'.
Also, be sure to back up the following data with RUI in advance because the data will
be reset to the value at the time of factory shipment.
-Address Book
-User data
-Additional Functions Mode
Import the backup data with RUI after performing ''ALL CLEAR''.
2--
1. Be sure to upgrade the BOOT to 'v00.60 or later' when upgrading the System Software
from 'v50-xx or earlier' to 'v61-xx or later'.
Be sure to upgrade the BOOT before upgrading the System.
3--
Compliance with Lot6 for products for Europe:
- Version upgrade for products for Europe.
- No need to install other than the products for Europe.
- Do not install the former version to machines complied with Lot6 to be delivered to
Europe because only from this version it complies with the European environmental
rules (Lot6).

[Cabo]

I have this problem. Problem is in the duplex clutch

[SAZ911]

Hi,


Had a similar issue with an IR4025 but the fuser units are the same so maybe this will help.

Follow link below,

Canon iR Adv 4025i Jam 0107

Cheers,