C2230 - Not printing in line, out of alignment.

[Benjamin98]

Hi all,

Compliments of the season to you all.
I have the above machine that is giving me an issue where the PG10 colours are out of alignment and won't change. I've changed some drums especially the Cyan & Magenta as they seemed to be leaving a residual transfer behind. I have done an Auto color correct mismatch and also changed the ITB and registration sensor assembly but they didn't make any difference at all.

I have attached a PG10 for review so you can see what I mean. 20160106141232.pdf

Thanks for the assistance.

Ben

[ernesto]

Hi all,

Compliments of the season to you all.
I have the above machine that is giving me an issue where the PG10 colours are out of alignment and won't change. I've changed some drums especially the Cyan & Magenta as they seemed to be leaving a residual transfer behind. I have done an Auto color correct mismatch and also changed the ITB and registration sensor assembly but they didn't make any difference at all.

I have attached a PG10 for review so you can see what I mean. 20160106141232.pdf

Thanks for the assistance.

Ben

Hi,

you can try to clean two patch sensor and after that you can do an auto color correct mismatch again ....

ALL THE BEST

[mramlawi]

Hi,

also as i remember you can make adjt for the laser on level two function laser and press on it start for all the colors the. Make mismatch and quick adjt the. Full adjt and try