I have replaced the Flat cable, exchanges the reader board and the CCD unit cleared up for about a week then the
error E-0248-001 comes back
I have replaced the Flat cable, exchanges the reader board and the CCD unit cleared up for about a week then the
error E-0248-001 comes back
I'm assuming that you've re-entered all the applicable values back into the reader pcb fresh, not backed up and imported back from service mode. Updated and overwrite all firmware?
You could try Rcon backup. Then do a Rcon clear, turn off and on then put the values under the cover of the reader controller back in. You can always do a Rcon restore if that does not work. Possible one of your parts swapped out is bad but I think unlikely. I hate problems like that! Hope you fix it. I got this idea off canon website, have not had this yet. There is also a flaky cable going from reader controller to main controller that fixed one machine (4235) with a different code.
Bookmarks