Hi,
I have an intermittent error 100,it has been changed laser unit, dce controller and removed laser shutter...
Does anyone know what can be the problem.....?
Hi,
I have an intermittent error 100,it has been changed laser unit, dce controller and removed laser shutter...
Does anyone know what can be the problem.....?
replace dc controller did you do?
very old machine ...
maybe it's a bad contact from the metal registration roller to the little earth-spring at the side of this roller: clean the area there and some electro spray will take away this error
I've always used conductive grease on that registration contact. or you'll get rust and screeching. I have not had any negative results from using the conductive grease. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
little earth spring.jpg
does it mean that small metal ?
Bookmarks