Thanks: 
Likes: 
Dislikes: I have replaced the drum unit, cleaned all the scanner glass and this IR still has a light header only in copy not in print and ive cleaned the optic any ideas? thank you
I have replaced the drum unit, cleaned all the scanner glass and this IR still has a light header only in copy not in print and ive cleaned the optic any ideas? thank you
Misstake, there is a light shaded area on the paper in the print,I have checked the dv rollers, they both look clean, there is dv all the way across the dv roller, is there a laser lens some where to be cleaned?
new drum unit installed....thanks
Yes there is a laser in this copier. It is under the output tray and probably is dirty along one edge of all the mirrors in it.Originally Posted by digicor
you mean inside the laser? I cleand the outside lens, can this be removed from the top by taking the out put tray off?
Transfer Roller may be out of position.
Check the Pins that holds the transfer roller in place.
SEE EXAMPLE -------->of undamaged rear side Transfer Hinge Pin
The part numbers for the Transfer Hinge Pin are as follows:
FC5-1536-000, Transfer Hinge Pin (Rear)
FC0-4340-000, Transfer Hinge Pin (Front)
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Yes you can remove laser by taking the output tray off and it is under it. The cover comes off laser and you can clean the mirrors VERY CAREFULLY.
Yes these pins come out very often. Do a skyshot or test5 and open the door while paper passes by drum. Light on drum image...laser,charge,dev,etc. Not light on drum would be transferTransfer Roller may be out of position.
Check the Pins that holds the transfer roller in place.
SEE EXAMPLE -------->of undamaged rear side Transfer Hinge Pin
The part numbers for the Transfer Hinge Pin are as follows:
FC5-1536-000, Transfer Hinge Pin (Rear)
FC0-4340-000, Transfer Hinge Pin (Front)
thank you for the info, ill take a look at it
Posting Permissions
Reply With Quote
Bookmarks