canon c3200 output every ten copies has one or two see the bottom
drum need to be replace?magenta?
Thanks: 0
Likes: 0
Dislikes: 0
canon c3200 output every ten copies has one or two see the bottom
drum need to be replace?magenta?
Originally Posted by ps22sp
do lines move from position shown ??
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
lines are original design.
the problem is words
---------------------------
kissena boulvard
flushing ny 11355
----------------------
those characters
=====
What type of paper stock being used_?
Go into the Service mode COPIER>OPTION LEVEL 2>BODY and adjust FX-SPD and EX-PS-SP and set to +2.
FX-SPD adjusts the fixing roller speed and EX-PS-SP adjusts the Paper Delivery Vertical Path Motor speed.
NOTE: These values can be adjusted between -2 and +2. Factory specification is at 0
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Are the yellow lines supposed to be there along the bottom of the image? I think maybe not. It's looks a lot like a repetitive defect. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I believe it's fixing problem.
img803 (1).jpg
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
I'm with Zoraldinho, looks like smudgeing... Can you whipe off or smear the toner when it does this ?
If it was the drum i'd expect this to be on every printout...
Johan
poster needs to indicate if issue is only on trailing edge of copies ???
& type of paper stock ???
could just be stock issueoutput every ten copies has one or two
Increase the fixing speed for heavy media with service mode level 2 COPIER>OPTION>BODY>FX-SPEED2 (the larger the value the faster the fixing speed).
canon c3200 output every ten copies has one or two see the bottom
drum need to be replace?magenta?lines are original design.
the problem is words
I believe poster means magenta text smear/blast on bottom on image ?????????
smear.jpg
I would remove ITB--- then remove bottom metal plates----clean underside---inspect if either plate has a slight bend ??? any slight bend interferes with image on belt--especially on trailing edge of long side stock ( that stock has a tendency to lift up a bit on separation -
Last edited by teckat; 09-22-2016 at 05:21 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Posting Permissions
Reply With Quote
Bookmarks