IR Adv 8105 E001-002 on A5, B5 and A4-R

[Canuck]

8105 has no shutter...ends are overheating on small stock.

[Canuck]

have you check the thermostat? thermostat it can also control the heat temperature if overheat detect from hot roller that is automatically switch off do not just focus on thermistor, the two parts was designed to protect for overheating......

Totally incorrect....thermostat will open if over heated. NO EFFECT ON TEMPERATURE CONTROL AT ALL. If it opens it will not reset by itself and machine would be down...service mode reset will not fix it in this case. To reset thermostat,stick it in the freezer for a while then smack it with a screwdriver handle. Been resetting them like this for 25 years.

[PCC.TONER]

why error: E001-002

Fixing Assembly high temperature error (software detection). The Fixing Main Thermistor (THM1) detects 230 degC or higher. The Fixing Sub Thermistor 1 (THM2)/Fixing Sub Thermistor 2 (THM4) detects 230 degC or higher for 2 consecutive seconds.

Solution:

1. Check if the cable of the Thermistor is caught. -> Replace the Thermistors. -> Replace the Fixing Assembly. 2. IH control error. -> Replace the Fixing Power Supply PCB (PCB10), the DC Controller PCB (PCB1), or the Main Driver PCB (PCB2).

Hope it is useful for you.

Linda



--------------------------------------------------------------------------
china spare part, Toner chip, Copier parts, Toner Cartridge - einmay toner

[tinnyjay]

I agree, if you have replaced (or swapped) all thermistors then i'd look at the fixing roller, especially if it's non OEM!

Non oem roller was the problem! Learned something new
Thank you all!

[tinnyjay]

Should check on epartsroom they have remam fixing assembly OEM or used

Thank
you
us -a.jpg