i have canon i-Sensys MF623Cn display code error E000-0000 after moments
help me please
i have canon i-Sensys MF623Cn display code error E000-0000 after moments
help me please
are you doing any checks ? or u want instant solutions
The DC controller determines failures of the fixing assembly under conditions below to stop the fixing heater drive signal output
(FSRD+, FSRD-) and shut off relay and power supply to the heater. At the same time, it notifies the failure occurrence to the main
controller.
1. Start-up failure detection
• The thermistor temperature does not exceed startup temperature 1 within the pre-defined time after start-up of the heater
from the waiting status.
• The thermistor temperature does not exceed startup temperature 2 within the pre-defined time after reaching startup
temperature 1 upon start-up of the heater from the waiting status.
• The thermistor temperature does not reach the target temperature within the pre-defined time after heater temperature
control during initial rotation.
[Related error code] : E000-0000
E000 0000 = Error in temperature rising of Fixing Assembly
Temperature of the Fixing Assembly did not reach a certain temperature within the specified
period of time.
1. Check the connector connection between the Fixing Assembly and the DC Controller
PCB.
2. Replace the Fixing Assembly.
3. Replace the DC Controller PCB.
CAUTION:
When installing/removing the Fixing Film Unit , be sure not to touch the Fixing Film
Best to purchase a manual ----
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks