Ir9070 restarting during printing

[Matoku]

Hi all,

Today I have a problem with my ir9070. it keep restarting when doing my job.

the machine start up as normal and ready to copy. When copying in 50 cps and in the middle the machine restart it self
and causing the job stop. the machine restart. after remove paper jam due to the machine restart, then it ready.

I have no idea what to do. I tried check for any short circuit on power supply, main controller, DC controller and AC drive PCB. I chcked for any
wire shorted. But still The same.

Any Idea and suggestion a really appreciated.

Matoku.

[Canuck]

Check for errors and alarms logged.. Disconnect cleaner blade vibration motors and run it...7105 would not start up because of this(same machine basically). The wiring to them shorts and it will take machine down. Replaced many in the past. Just unplug the connector for them at top of process unit and run it... if ok replace the motors and harness. Another thing to do is cleaned and reseat all memory cards(boot,sram,etc)