error code E000520 need help , appreaciate .
error code E000520 need help , appreaciate .
How to clear E000
Enter service mode by pressing additional functions than 2 than 8 and then Additional Functions.
#SSSW will be displayed.
Use the right arrow and scroll to #CLEAR then press OK.
Use the right arrow and scroll to ENGINE then press OK.
ERRCLR will be displayed then press OK.
Then power cycle the machine.
are u sure about that e000520 ????
never seen than -520 Detail Code on this model
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I think this is shorter, finisher, unit problem.
If machine have a finisher unit , than try you disconnected from machine and try a check.
ARUN KUMAR MISHRA
Upgrade firmware.Call Canon.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Check the DIMM Assembly on the Main Controller ---remove and re-seat it.
May also be bad------------------------
DIMM.jpg
Copier display is locked up with a message of 'Network Download Available' at power on.'
The message occurred after the Main Controller was replaced.
After comparing the original Main Controller and the replacement Main Controller, it was noticed that the position of the dip switches on the dip switch bank were in different positions.
Setting the dip switches on the replacement Main Controller to the following resolved the network download available message at power on.
Set dip switches 1, 2 and 3 on and bit 4 "off"
kbase123204-2.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
This is what the manual says.
Hope it helps
E520 0001
Title Shift Motor (M4) error
Description The shift roller does not leave the shift roller home position
when the Shift Motor (M4) has been driven for 1.2 seconds.
Remedy 1.Replace the Shift Roller HP Sensor (S2).
2.Replace the Shift Motor (M4).
3.Replace the Finisher Controller PCB (PCB1)
Bookmarks