This morning, I meet a problem my copier machine iR3045 with error code E000110-0001.
Please help me what i should do?
Ty
This morning, I meet a problem my copier machine iR3045 with error code E000110-0001.
Please help me what i should do?
Ty
Check Laser unit and DC Controller.Check Fuse on the DC Controller
Thank you for reply,
I have checked the Fuses on DC Controller with result:
Fuse 1 = 0,05 (buzzer)
20170726_172634Fuse1ps.jpg
Fuse 2 = 0,03 (buzzer)
20170726_172554Fuse2ps.jpg
Fuse 3 = 1,666 ( no buzzer)
20170726_172700Fuse3ps.jpg
What is the third conclusion of that measurement result?
Remember that u can't check a fuse that is in series on a board.
If in series, u can get a false read as good or bad, especially if another component is good or bad.
How to test a fuse in a circuit.
Testing the Fuse😱
Turn the device off first and Remove power.
Remove the fuse from the vehicle or device.
Make sure it is turned off before the fuse is removed.😱
Turn the meter on and set it.
You can rotate the selector to Ω, or OHMS. ...
Put one lead on each end of the fuse and look at the display. ...
Test the fuse.
By using an Ohmeter to check continuity of componets still in a circuit, you may also be checking other (non-fuse)componets in the circuit as well, thus giving misleaading indications.
Using a low Ohms setting on the meter might help eliminate (somewhat) this problem.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Did u note where u removed it from on pcb ?
Post a pic of fuse.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
This's pict my fuses
20170809_115448.jpg
20170809_115508.jpg
Thank you for reply
When the side door is closed, the laser shutter is opened via a cable that goes from the interlock area around to the laser where it opens it from underneath. I have seen this cable broken. Or you may simply have a bad laser unit.Found this also
Error :
Error code E100/110
Workaround :
After replacing the laser, laser motor, main controller, dc controller, and checking the wiring the problem was resolved by replacing the registration sensor.
Problem :
Error and jam codes are very intermittent. J0201 happens with no paper in path, history showed E100-0001 & E110-0000. Replaced Laser Assembly and PS10 then tried a DCON clear with no change in codes.
Solution :
Replacing DC Controller { FM3-1262-000 for 3025 & 3030 }{ FM3-1263-000 for 3035 & 3045 } resolved issue
Error :
E100, E110 Error Codes
Workaround :
Although the Main Power Supply, Controller Power Supply, DC Controller, Laser, and Drum, were replaced for this issue, the Accessories Power Supply Pcb. resolved the problem (Part number FK2-0338-000).
Last edited by teckat; 08-09-2017 at 03:25 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks