Kindly Check Image for your reference.
second image was when i replaced the registration clutch, but there is still slight fold in the middle.
how to resolve this issue?
thanks
Kindly Check Image for your reference.
second image was when i replaced the registration clutch, but there is still slight fold in the middle.
how to resolve this issue?
thanks
Only first one or two prints or always?
First start with fresh,dry paper.
Inspect and lubricate thin orange roller in fixing unit.
Inspect>remove>foam dumpers.
Clean or replace pickups and feed rollers.
Last edited by zoraldinho; 09-12-2017 at 02:10 PM.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Internal finisher? No finisher? Check switch right before sync roller, steel cover on switch, guild plate out of alignment. just a couple of thing to also check.
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Most likely Fuser unit. Before you change it. Open the fuser and put a drop of oil on the ends of the skinny orange roller. This is on the outside guide. If you want to do it by the book, remove the assembly and apply conductive grease to the ends. This pencil size roller can cause a drag on the paper and make the bends.
If that doesnt work its time for a new fuser.
hi good day.
we have recently changed the fixing unit.
second picture is still the output.
Can you make a copy through the manual feed without any noise or studder? Is the lower door hinge cracked or loose.
Bookmarks