Canon IRA C5235i Slow Prints / Copies

[SAZ911]

hi

if its slow without network cable plugged in and copies aswell.then it might be the HDD.try do a firmware over ride all update.
if that doesn't work you might need to do a format then update.

if you have the same mc in the same place u can take hdd from other mc to test to see if copies are faster

Hi All,

Just to update you guys, I tried formatting and redoing firmware from new,

Unfortunately it didn't make a difference for copies nor printing, still runs slow.

I have order a Main Controller II and will post my results in a few days hopefully.

thanks .....,

[Canuck]

Replace the fixing film assembly. I get these calls all the time...copies and prints slow. Rust and dried grease inside the assembly soil thermistors,etc. What is the meter reading?

[SAZ911]

Replace the fixing film assembly. I get these calls all the time...copies and prints slow. Rust and dried grease inside the assembly soil thermistors,etc. What is the meter reading?

Hi Canuck,

Spot on, thanks...... (Slow Duplex Printing solved by replacing Fixing Assy)

I did check the fixing assembly for temp loss but it seemed to be fine, Even compared to another device.

Fortunately i had another device (IRAC 52XX) come in yesterday afternoon, so i had the opportunity to swap the complete fixing assemblies over.

It worked perfectly with the swapped out fixing assembly, so thanks for saving me from buying a Main Controller II.



Thanks to everyone for your ideas and suggestions, much appreciated......


cheers.....

[zoraldinho]

Thanks for update!

[geltrons]

I am also having slow printing problem with 5235 .
Upon switching on, the machine starts normally
But after the machine is ready it displays starting up
In the bottom part of the display for at least
15 minutes. During this time copying is ok .but
No printing and internal prints .
Once theachine is ready any internal test pages
Takes 3 minutes, same for any prints form PC
It displays processing for a long time .

Replaced HDD from a working machine result is same
(I had experienced the same problem before but
When hard disk from a working machine is swapped
It will be ok )

Any ideas pls