SAZ911..........
Replace the fixing film assembly. I get these calls all the time...copies and prints slow. Rust and dried grease inside the assembly soil thermistors,etc. What is the meter reading?
Hi Canuck,
Spot on, thanks...... (Slow Duplex Printing solved by replacing Fixing Assy)
I did check the fixing assembly for temp loss but it seemed to be fine, Even compared to another device.
Fortunately i had another device (IRAC 52XX) come in yesterday afternoon, so i had the opportunity to swap the complete fixing assemblies over.
It worked perfectly with the swapped out fixing assembly, so thanks for saving me from buying a Main Controller II.
Thanks to everyone for your ideas and suggestions, much appreciated......
cheers.....
SAZ911..........
Thanks for update!
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
I am also having slow printing problem with 5235 .
Upon switching on, the machine starts normally
But after the machine is ready it displays starting up
In the bottom part of the display for at least
15 minutes. During this time copying is ok .but
No printing and internal prints .
Once theachine is ready any internal test pages
Takes 3 minutes, same for any prints form PC
It displays processing for a long time .
Replaced HDD from a working machine result is same
(I had experienced the same problem before but
When hard disk from a working machine is swapped
It will be ok )
Any ideas pls
Bookmarks