Hi Guys I know this is a very old machine but slight problem The machine takes a while to warm up and then when you make a copy it does not come ready for about 10 seconds after copy is delivered..Hard drive problem i am thinking?
Hi Guys I know this is a very old machine but slight problem The machine takes a while to warm up and then when you make a copy it does not come ready for about 10 seconds after copy is delivered..Hard drive problem i am thinking?
usually you get a error code for HDD issues, usually. How old is the fuser, wonder if it is keeping the right temp. Could be a few things, what have you done or tried?
Hello Teckat No I have not checked that out . The machine is in an office on its own and other electrical items working ok I might try a change of fuser if I can locate one tks for tip
Ok Guys wall voltage ok constant at 230V the machine produced the dreaded error code today E602-003 so must have been a Hard Drive problem all along I removed and cleaned the Dimm so I guess that is the end of a great machine as there are no Hard drives available I cant even get into the service mode to do a check disc
Try holding down 1 and 9 key while powering on printer, this puts printer hdd into defrag mode
Shows white blocks dropping on menu, u may get a NG if HDD is bad
Old refurbished had available online.
Amazon.com: Buying Choices: HDD Hard disk for IR2200 2800 3300 ir2800 ir3300 FK4-0927-000
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I may have a hard drive with the IR2200 system software installed on it. PM me if you still need it?
Hi, you can change the HDD and download the firmware.
Bookmarks