No oil needed just grease was used. I pulled the feed section out and cleaned and used Grease and that fixed the problem. Thanks for all the suggestions
Drums are notorious for squeaking. Oil them all the time....ends of primary(small drop on each end), pull out the drum ground clip on the end a little bit and put a dab of conductive grease, also a drop of oil on drum flanges ends(white plastic). Sometimes the delivery bushings in the fuser squeak(cheap, not Oilite). Drop of oil...
I prefer to use grease, oil is to thin and runs from between the bearing.
G-50000H--Semisolid=FY9-6022-000
USE--Plastic,Rubber,Metal (Normal temperature and low pressure location)
MOLYKOTE G-8022=FY9-6026-000
USE--Metal (High temperature and high pressure location)
Bookmarks