Canon Ir adv 8205

[Saji]

Canon ir advance 8205, giving e 61-000, I checked,and replaced pretransfer corona,and sensor,it works fine in another machine.what could be the other reasons for the error. Please help.

[roho]

Check the primary corona, more likely the cause of that error then the pre transfer.

[Saji]

I replaced primary corona and the sensor as well.but problem remains.thanks

[zoraldinho]

Can you print a test page with potencial control off?
Inspect quality of drum surface.

[ReproKev]

High humidity location? I had a similar E061 problem with a customer running a machine out of their home garage.Turn off potential control until the environment improves. Quality will probably suffer but that's not your problem if the customer doesn't control the copiers environment.

[Saji]

I off the potential control,but still the error coming. Any other things I have to check? Kindly help.

[Saji]

I off the potential control,but still the error coming. Any other things I have to check? Kindly help.

[guitar9199]

1. Check the connection of the Pre-exposure LED (connector
connection, open circuit, the caught cable).
2. Check the installation of the Primary Charging Assembly
(connector connection, open circuit, the caught cable).
3. Check the fixation state of the Drum and the Drum Shaft.
(Check if the drum fixation cylinder is properly installed.)
4. Check if the Dustproof Glass is soiled. If necessary, clean it.
5. Check the installation of the Laser Scanner Unit (connector
connection, open circuit, the caught cable).
6. Check the installation of the Primary Charging High Voltage
PCB (PCB11), and its connection (connector connection,
open circuit, the caught cable).
7. Check the installation of the Potential Sensor (connector
connection, open circuit, the caught cable).
8. Check the installation of the Drum Motor (M1), and its
connection (connector connection, open circuit, the caught
cable).
9. Replace the parts.
• Primary Charging Assembly
• Laser Scanner Unit
• Potential Sensor
• Primary Charging High Voltage PCB (PCB11)
• Drum Motor (M1)
• Main Driver PCB (PCB2)
• DC Controller PCB (PCB1)

[nicknt82]

Canon ir advance 8205, giving e 61-000, I checked,and replaced pretransfer corona,and sensor,it works fine in another machine.what could be the other reasons for the error. Please help.

Also check Drum lock Screw or groud plate inside Drum after check Transfer unit