Canon ImagePress C6000 error code

[Laka]

Hello!
We have a errorcode E000001-0250-05 on our C6000VP
Presume it is the second fixing unit - but where to check ?
Regards
Lars

[zoraldinho]

Inspect:

Secondary fixing>Fixing roller main thermistor

[aAandy]

Inspect:

Secondary fixing>Fixing roller main thermistor

to check a thermistor electrically, put a multimeter across the two wires and you should get anywhere between 150k - 350k ohms resistance - when you hold the thermistor contact between your fingers you should see the resistance drop quickly

if it is open circuit or the resistance doesn't change with heat - it's stuffed, replace it.

Also if you notice physical wear on the contact surface, replace it.

[zoraldinho]

to check a thermistor electrically, put a multimeter across the two wires and you should get anywhere between 150k - 350k ohms resistance - when you hold the thermistor contact between your fingers you should see the resistance drop quickly

if it is open circuit or the resistance doesn't change with heat - it's stuffed, replace it.

Also if you notice physical wear on the contact surface, replace it.

I believe that he knows how to check the thermistor. Otherwise, it's better to call an authorized Canon service for the imagepress 6000.

[cirujano]

Hello!
We have a errorcode E000001-0250-05 on our C6000VP
Presume it is the second fixing unit - but where to check ?
Regards
Lars

1. Check for any caught harnesses. => Replace them if
necessary.
- fixing roller main thermistor
- between the fixing roller main thermistor and the fixing
external driver PCB
- between the fixing external driver PCB and the fixing
duplexing feed driver PCB
- between the fixing duplexing feed driver PCB and the DC
controller PCB 1-2
2. Check that the fixing roller main thermistor is clean and
properly installed. => Clean and reinstall it if necessary.
3. Replace the following parts if necessary.
- fixing roller main thermistor
- fixing heater driver PCB
- fixing external driver PCB
- fixing duplexing feed driver PCB
- DC controller PCB 1-2

x= 1: Primary fixing
2: Secondary fixing
Fixing roller main thermistor:
THM301(primary fixing),
THM306(secondary fixing)
Fixing external driver PCB: UN304(primary
fixing), UN305(secondary fixing)
Fixing heater driver PCB: UN306(primary
fixing), UN307(secondary fixing)
Fixing duplexing feed driver PCB: UN311
DC controller PCB 1-2: UN124

[zoraldinho]

I believe this problem was solved long time ago.