Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Field Supervisor 500+ Posts Desert Rat's Avatar
    Join Date
    May 2008
    Location
    Valley of the Sun
    Posts
    910
    Rep Power
    31

    C3380i with Z1 finisher not stacking correctly

    I spent a couple of hours on this problem. When the paper exits the finisher it does not pull it back
    in to stack. The sheets get skewed on something. I have not seen what it is getting skewed by.
    It looks like I would have to remove the finisher to do just about anything.

    So, has anyone had any experiences like this on that finisher?

    Thanks

    DR


  2. #2
    Service Manager 2,500+ Posts
    C3380i with Z1 finisher not stacking correctly


    Join Date
    Jan 2014
    Location
    London
    Posts
    2,957
    Rep Power
    0

    Re: C3380i with Z1 finisher not stacking correctly

    There are a couple of rubber arms that pull the paper back in, give them a good clean.

    Best to remove this finisher rather that try & work on it in the machine, only a few screws unit comes out.

    Also check you don't have limited functions mode on.


  3. #3
    Senior Tech 250+ Posts MunsterTech's Avatar
    Join Date
    Sep 2014
    Location
    limerick
    Posts
    263
    Rep Power
    11

    Re: C3380i with Z1 finisher not stacking correctly

    Had this before, there are also little black rubber bands, very thin that sit in a groove on some white rollers, these break off and cause alot of issues when skewing. You will probably see one missing, easy enough to spot


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here